Monessen Hearth Direct Vent Gas Fireplace KHLDV SERIES - Manual (Page 32)

32 73D0024
Step 4 Step 5
5. Place the upper left log at angle over the rear and the middle logs by matching the indentation on the bottom of the log
with protrusion on the rear log. Set the pointed end of the log over the flat surface of the middle log. When this log is in
place the pointed end will come in contact with the back of the pilot log placed in step #2.
6. Place the right upper log over the pilot log and the hearth brick by matching the indentation on the bottom of the log
with the protrusion on the pilot log.
7. Place the upper right rear log over the rear log and the right upper log by matching the indentations located at the bottom
with the protrusions on the rear log and the right upper log.
8. Replace glass in reverse order of instructions on page 29.
9. Slide the rings of the screen provided inside the unit above the grate over the rod. Make sure the screen handles are
toward the center.
10. Hook the rod screen assemblies over the three hooks located behind the face in front of the glass. Note: The opening of
the hooks are toward the back.
Step 7
FINAL INSTALLATION
Step 6