Intermec EASYCODER PL4 - Manual (Page 12)

12 EasyCoder PL4 Printer User’s Guide
Note: A fault condition is caused by a problem with the
battery. The charger may indicate a fault because the battery
is too hot or cold to charge reliably. Charge batteries between
0
°C to 45°C (32°F to 113°F). If the amber indicator starts
flashing on the second attempt, the battery should be
discarded.
4-Pack Charger Cycle Times for PL4 Batteries
Percentage Charged Time
Battery 80% Charged 2.5 hrs.
Battery Fully Charged 5 hrs.
These times are for completely discharged batteries. Batteries
that are only partially discharged will take less time to reach their
charged state. You can use batteries that have reached 80% of
their charge capacity, but we recommend you allow the batteries
to reach a full charge to maintain maximum battery life.
The 4-pack battery charger has a safety feature that stops
charging a battery after 6 hours regardless of its charge state.
Do not allow your battery charger to come in contact with
any conductive material. It creates a short circuit that
could cause burns and other injuries or could start a fire.
Use of any charger not approved specifically by Intermec
for use with its batteries could cause damage to the
battery pack or the printer and will void the warranty.
Attention: Le chargeur de batterie ne doit pas entrer en
contact avec un matériel conducteur. Dans le cas
contraire, un court-circuit risque d’entraîner des brûlures
et d’autres blessures ou de provoquer un incendie.
L’emploi d’un chargeur non approuvé de façon spécifique
par Intermec pour utilisation avec ses batteries risque
d’endommager le bloc-batterie ou l’imprimante et
annulera la garantie.