Verifying the printer is working – Intermec EASYCODER PL4 User Manual
Page 22
22
EasyCoder PL4 Printer User’s Guide
PL4U015.eps
Rear
media
slot
Media
spacer
Surface of media
to be printed
5
Close the media cover and then rotate the latch assembly
until it locks in place.
6
Turn on the printer or press the Feed button if the printer is
already on.
The printer advances the media to the next label, if printing
labels. If you are printing on continuous media, the printer will
advance a short strip of media and will then be ready for
printing.
Verifying the Printer Is Working
Before you connect the printer to your computer or portable
data terminal, make sure that the printer is in proper working
order. You can do this by printing a configuration label using
the next procedure. If you cannot get this label to print, refer to
“Troubleshooting” later in this guide.