Intermec EASYCODER PL4 - Manual (Page 19)

EasyCoder PL4 Printer User’s Guide 19
The supports adjust themselves to the width of the media.
The media should be able to spin freely on the supports.
4 If you want to use the printer in Tear-Off mode, go to the
next step.
If you want to use the printer in Self-Strip mode, peel a few
labels off of the media.
5 Close the media cover.
6 If you want to use the printer in Tear-Off mode, flip the
self-strip bar down away from the latch assembly.
If you want to use the printer in Self-Strip mode, slide the
self-strip bar up with your thumbs until it locks into place on
the latch assembly.
Latch
assembly
Self-strip
bar shown
in tear-off
position
Media
cover
Label
Tear-Off mode
Self-Strip mode Media
cover Backing
Latch
assembly
Self-strip
bar shown
in self-strip
position
PL4U045.eps