Intermec EASYCODER PL4 - Manual (Page 17)

EasyCoder PL4 Printer User’s Guide 17
* The highest baud rate with consistent results is 38400.
** Some parameters, such as the WLAN ID number and non-standard no-
activity time out values can be set using a PC running Intermec PLUS and
a data cable link to the printer.
The LCD has a backlight option that allows viewing of the
screen in a dark environment or provides better contrast in a
very bright environment. Using the backlight decreases the time
the printer runs between charges. Refer to the section
“Extending Battery Life” for more information.
Loading the Media
You can operate this printer in one of two different modes:
Tear-Off or Self-Strip. Tear-Off mode allows you to tear off
each label (or a strip of labels) after it is printed. In Self-Strip
mode, the backing material is peeled away from the label as it is
printed. After you remove this label, the next one is printed.
The PL4 printer supports direct thermal receipt, label, or tag
media.
Note: To print a configuration label, you need to load
continuous media (media with no black marks or gaps) into
the printer. The printer shipped with a sample roll of
continuous media. For help printing a configuration label, see
“Verifying the Printer Is Working” later in this guide.
To load the media
1 Press the latch release button on the side of the printer. The
latch assembly flips open automatically.
2 Rotate the media cover back to expose the media
compartment and the adjustable media supports.