IBM INFO PRINT 3000 - Manual (Page 263)

d. When you have made all the changes, SELECT the OK pushbutton. You see
the Configure Attachments window. If you want to change configuration
information for other attachments, repeat the previous steps as necessary.
e. When you have made all attachment changes, SELECT the OK pushbutton
on the Configure Attachments window. You see the Restart prompting
window.
f.
If you have other configuration changes to make, you can make them before
you restart the system. If your configuration changes are complete, SELECT
the Restart pushbutton to make them effective.
Note
SELECTING Restart does the following:
v If you are making this change in duplex or simplex mode, a window
appears that informs you that an automatic Shutdown procedure has
started. This window is followed by a window stating that the system
is being rebooted (AFCCU microcode is being reloaded). At the
completion of the microcode reload, the attachment changes are in
effect. You do not have to power off the system and then power it on.
v If you are making this change in dual simplex mode, the Display Touch
Screen screen goes blank while an internal Shutdown procedure is
executed on the printer on which you are working. The system then
displays a message that indicates that the other printer must be
shutdown for the changes to take affect. This message is followed by
the Display Touch Screen window for the other printer.
You must select the Shutdown/Restart procedure from the Operate
pull-down menu on that Display Touch Screen window, and then
execute the Shutdown routine. A window appears stating that the
system is being “rebooted”. At the completion of the reboot, the
attachment changes are in effect with no system power-off and
power-on procedure required.
Chapter 8. Configuring the System
231