IBM INFO PRINT 3000 - Manual (Page 82)

Options Pull-Down Menu
Figure 14 shows the selections available on the Options pull-down menu.
Assign Form to Load...
Assigns the defined name of the form you are loading. (A form does not
appear on the list until you define it.) From within this procedure, you can
also invoke the Adjust Print and Print Test procedures. See “Loading
Forms (Simplex or Dual Simplex Mode)” on page 102 or “Loading Forms
(Duplex Mode)” on page 115 for more information.
Enable/Disable Attachments...
Lets you enable and disable the host system attachments that are installed
on the system. See “Enabling and Disabling Attachments” on page 63 for
more information.
Password...
Lets you set the authorization level of the person who is working on the
printer. It also allows you to change the user authorization password.
Access to higher user authorization levels is password protected. See
“Changing the Password or Authorization Level” on page 79 for more
information.
Change Language...
Lets you change the language that is used for all text within Display Touch
Screen windows. See “Changing the Language of Messages” on page 218
for more information.
Clean Screen
Gives you 30 seconds to clean the face of the monitor. If one 30 second
interval is not long enough, you can repeat this procedure as many times
as necessary.
Operate Configure Analyze Options Help
Ready Check Reset NPRO Cancel Job
HC6OG091
Assign Form to Load...
Enable/Disable Attachments...
Password...
Change Language...
Clean Screen...
Calibrate Touch Screen...
Front Face...
Special Features...
Figure 14. Options Pull-Down Menu
50
InfoPrint 3000 Operator’s Guide