Intel Extensible Firmware Interface - Manual (Page 1025)

Alphabetic Function Lists
Version 1.10 12/01/02 K-15
Table K-1. Functions Listed in Alphabetic Order (continued)
Function Name Service or Protocol Subservice Function Description
Shutdown UNDI Commands Resets the network adapter and
leaves it in a safe state for another
driver to initialize.
SignalEvent Boot Services Event Services Signals an event.
Stall Boot Services Miscellaneous
Services Stalls the processor.
Start EFI Driver Binding
Protocol Starts a device controller or a bus
controller.
Start PXE Base Code
Protocol Enables the use of PXE Base
Code Protocol functions.
Start Simple Network
Protocol Changes the network interface
from the stopped state to the
started state.
Start UNDI Commands This command is used to change
the UNDI operational state from
stopped to started.
StartImage Boot Services Image Services Function to transfer control to the
Image’s entry point.
Station Address UNDI Commands This command is used to get
current station and broadcast
MAC addresses and, if supported,
to change the current station MAC
address.
StationAddress Simple Network
Protocol Allows the station address of the
network interface to be modified.
Statistics Simple Network
Protocol Allows the statistics on the
network interface to be reset
and/or collected.
Statistics UNDI Commands This command is used to read and
clear the NIC traffic statistics.
Stop EFI Driver Binding
Protocol Stops a device controller or a bus
controller.
Stop PXE Base Code
Protocol Disables the use of PXE Base
Code Protocol functions.
Stop Simple Network
Protocol Changes the network interface
from the started state to the
stopped state.
Stop UNDI Commands This command is used to change
the UNDI operational state from
started to stopped.
continued