Intel SDS2 User Manual
Page 116
Intel® Server Board SDS2
Regulatory and Integration Information
Revision 1.2
Order Number: A85874-002
105
12.2.5
Use Only for Intended Applications
This product was evaluated for use in ITE computers that will be installed in offices, schools,
computer rooms and similar locations. The suitability of this product for other product categories
other than ITE applications (such as medical, industrial, alarm systems, and test equipment)
may require further evaluation.
12.2.6
Installation Precautions
During the installation and testing of the board, the user should observe all warnings and
cautions in the installation instructions. To avoid injury, be aware of the following:
•
Sharp pins on connectors.
•
Sharp pins on printed circuit assemblies.
•
Rough edges and sharp corners on the chassis.
•
Hot components (like processors, voltage regulators, and heat sinks).
•
Damage to wires that could cause a short circuit.
•
Observe all warnings and cautions that instruct you to refer computer servicing to
qualified technical personnel.
WARNING: Do not open the power supply. There is risk of electric shock and burns from high
voltage and rapid overheating. Refer servicing of the power supply to qualified technical
personnel.
12.2.7
External ICMB Cable Information
When the ICMB accessory is incorporated as part of a server solution, the external cable used to
connect the ICMB cards will need to be manufactured. Note the female connectors on the early
version and the universal version of the ICMB cards are different, as shown in Table 80: ICMB
External Cable Connectors.
The electrical specifications for this cable are available in chapter eight of the IPMI Intelligent
Chassis Management Bus Bridge Specification version 1.0 available at the following URL on the
Intel web site.
http://developer.intel.com/design/servers/ipmi/license_icmb11_old.htm
Table 90. ICMB External Cable Connectors
Product Code
Description
Female Jack for External Cable
AXX2ICMBKIT
Universal ICMB card for integration with:
SCB2, SDS2
Keyed RJ45 (Type B)