Invacare 9000 STANDARD WEIGHT - Manual (Page 38)

5 FRONT RIGGINGS
Invacare® Jymni™ Pediatric Series Wheelchair 38 Part No 1100868
5.5 Adjusting the Elevating Legrest Assembly
Raising Legrest Assembly
1. Assistant should grab hold of the lower legrest assembly and raise
elevating legrests until the desired height is obtained.
Lowering Legrest Assembly
1. Support user leg with one hand.
2. Perform one of the following:
•
Model J934A Elevating Legrest - Push release lever down with
other hand.
• Model J934A-14 Elevating Legrest - Push release lever forward
with other hand.
3. Gently, lower user leg down and rest against the legrest.
Adjusting Calfpad
1. Remove the elevating legrest assembly from the wheelchair. Refer
to Installing/Removing Elevating Legrest Assembly on page 37.
2. Remove the two mounting screws and washers securing the calfpad
to the elevating legrest as shown in Detail “A”.
3. Position the calfpad in one of the two height positions.
4. Reinstall the two mounting screws and washers securing the calfpad
to the elevating legrest. Securely tight.
Adjusting Height
1. Adjust footrest to correct height by loosening the nut and sliding
the lower legrest assembly up or down until desired height is
achieved as shown in Detail “B”.
2. Securely tighten nut.
FIGURE 5 Adjusting the Elevating Legrest Assembly
Calfpad
Washers
Mounting Screws
Elevating Legrest
Assembly
Release Lever
Lower Legrest
Assembly
Nut
Nut
Release
Lever
Lower Legrest Assembly
Detail “A”
Detail “B”