Invacare 9000 STANDARD WEIGHT - Manual (Page 69)

12 OPTIONS
Part No 1100868 69 Invacare® Jymni™ Pediatric Series Wheelchair
12.5 Installing/Removing the Solid Seat Insert
Installing
1. Position the solid seat insert so that it is fully supported by the seat rails and the back edge of the solid seat insert is touching the back canes.
Removing
1. Firmly grasp the solid seat insert and lift it away from the seat upholstery.
12.6 Installing/Removing the Solid Back Insert
Installing
1. Position the solid back insert between the back canes.
2. Wrap the two fastening straps around the back canes. Securely fasten with the two snaps.
Removing
1. Release the two snaps securing the two fastening straps around the back canes and remove the solid back insert.
12.7 Installing the Wheel Lock Extension Handle
1. Remove the existing rubber tip from the wheel lock handle (Detail “A”).
2. Install the extension handle over the wheel lock handle (Detail “B”).
FIGURE 4 Installing the Wheel Lock Extension Handle
ƽ
WARNING
If the wheelchair is equipped with push to lock wheel
locks, elevating legrests, and wheel lock extension handles,
the wheel lock extension handles MUST be removed
before swinging the elevating legrests to the side,
otherwise injury or damage may result. Interference
between the top of the elevating legrest and the wheel
lock extension handle causes the wheel lock to disengage.
Detail “A”
Rubber Tip
Wheel Lock
Handle
Wheel Lock
Detail “B”
Wheel Lock
Extension
Handle
Wheel Lock
Handle
Wheel Lock