Installing/adjusting stroller handles – Invacare 9000 STANDARD WEIGHT User Manual
Page 68
12 OPTIONS
Invacare® Jymni™ Pediatric Series Wheelchair
68
12.4 Installing/Adjusting Stroller Handles
Removing
1.
Remove the detent pin that secures one stroller handle to one of the
back cane.
2.
Remove the stroller handle
3.
If necessary, repeat STEPS 1-2 for the opposite stroller handle.
Installing
1.
Perform one of the following:
•
12-14-Inch Wide Wheelchairs - Insert one of the stroller handles
into one of the back canes so that it is facing either toward or away
from the inside of the wheelchair FIGURE 3.
•
10-Inch Wide Wheelchairs - Insert one stroller handle into one of
the back canes so that it is facing away from the inside of the
wheelchair FIGURE 3.
2.
Position the stroller handle so that the mounting hole in the back cane
aligns with the desired height mounting hole in the stroller handle and
secure with detent pin.
3.
Ensure the detent pin passes through the mounting hole in the back cane
and the desired height mounting hole in the stroller handle.
4.
Repeat STEPS 1-3 for the opposite stroller handle.
Height Adjustment
1.
Remove the detent pin that secures one stroller handle to one of the
back cane.
2.
Slide the stroller handle up or down until the desired height is reached,
making sure the mounting hole in the back cane aligns with the desired
height mounting hole in the stroller handle.
3.
Reinstall the detent pin so that it passes through the mounting hole in the
back cane AND the desired height mounting hole in the stroller handle.
4.
Repeat STEPS 1 - 3 for the opposite stroller handle.
FIGURE 3 Installing/Adjusting Stroller Handles
When closing a wheelchair with stroller handles, raise or
lower one of the stroller handles two hole heights.
Height Adjustment
Holes
Back Cane
Detent Pin
Stroller Handles
Stroller handles shown facing toward the inside of the
wheelchair.