Icom IC-208H - Manual (Page 28)

13
2
SETTING A FREQUENCY
■ Tuning step selection
[
Tuning steps are the minimum frequency change increments
when you rotate [DIAL] or push [Y]/[Z] on the microphone.
Independent tuning step for each frequency bands can be set
for individual tuning convenience. The following tuning steps
are available.
• 5 kHz • 10 kHz • 12.5 kHz • 15 kHz
• 20 kHz • 25 kHz • 30 kHz • 50 kHz
• 100 kHz • 200 kHz
☞NOTE: For convenience, select a tuning step that matches
the frequency intervals of repeaters in your area.
q Push [BAND] to select the desired frequency band.
• Push [V/MHz•SCAN] to select VFO mode, if necessary.
w Push [SET•LOCK] to enter set mode.
e Push [SET•LOCK] or [S.MW•MW] several times until “TS”
appears as shown below.
r Rotate [DIAL] to select the desired tuning step.
t Push [V/MHz•SCAN] to exit set mode.
z Push [BAND] to select the desired frequency
band.
• Push [VFO/LOCK] to VFO mode, if necessary.
x Push [
SET B(D-OFF)] to enter set mode.
c Push [
SET B(D-OFF)] or [ ENT C(T-OFF)] several
times until “TS” appears.
v Push [Y] or [Z] to select the desired tuning step.
b Push [
CLR A(MW)] to exit set mode.
SET
B
[SET•LOCK]