Icom IC-208H - Manual (Page 64)

49
9
DTMF MEMORY ENCODER
D Programming a DTMF code— via microphone
z Push [FUNC] then [
LOW
6(DTMF)] to turn the
DTMF encoder ON.
• “d” appears in place of 100 MHz digit.
x Push [
SET B(D-OFF)] to enter the DTMF memory
programming condition.
c Push [Y] or [Z] to select the desired DTMF
memory channel.
v Push the desired digit keys.
• When the first digit is input, previous memory con-
tents are cleared automatically.
• “E” stands for “M M” and “F” stands for “# .”
• Push [Y]/[Z] and repeat this step if you make a mistake.
• The S/RF indicator shows the digit group. The indi-
cation increases every 6 digits.
b Push [VFO/LOCK] to exit the programming condition.
• The [ CLR A(MW)] key cannot be used to exit. If pushed, code “A”
is input. Reprogram in such a case.
DTMF
[EXAMPLE]: Programming “5428AB453” into DTMF memory channel “D4.”
Push
Push Push
Push Push then .