Icom IC-208H - Manual (Page 43)

28
5
MEMORY OPERATION
5
D Programming a memory channel via the microphone
[EXAMPLE]: Programming 145.870 MHz into memory channel 20 (blank channel) via the microphone.
Push 10 times
Beep
“
Beep
“
Beep
Beep
Beep
“
“
“
“
“
Push Push then
Push then for 1 sec. and continue to push
➠
The microphone can also be used to program mem-
ory channels.
z Set the desired frequency in VFO mode.
➥ Push [VFO/LOCK] to select VFO mode.
➥ Set the frequency using the keypad.
➥ Set other data
(e.g. offset frequency, duplex direction, sub-
audible tone encoder ON/OFF and its frequency) , if neces-
sary.
x Push [FUNC] then [
CLR A(MW)] momentarily.
c Push [Y] or [Z] to select the memory channel.
• Direct numeral input cannot be used .
v Push [FUNC] then [
CLR A(MW)] for 1 sec. to program.
➥ 3 beeps may sound and the VFO contents (including
the subaudible tone frequency, etc.) are programmed.
➥ Memory channel number increases when continuing to
push [
CLR
A(MW)] after programming.
MW