Icom IC-208H - Manual (Page 9)

IV
QUICK REFERENCE GUIDE
D Optional MB-58 installation
The optional MB-58 REMOTE CONTROLLER BRACKET is avail-
able for separate installation.
q Drill 2 or 4 holes where the bracket is to be installed.
• Approx. 4 mm ( 1 ⁄ 8
″) when using nuts; approx. 1–2 mm ( 1 ⁄ 16
″)
when using self-tapping screws.
w Insert the supplied screws, bolts and washers through the
mounting base and tighten.
e Adjust the angle for the clearest view of the function dis-
play and tighten 2 screws when the mounting base is used.
r Attach the supplied Velcro pads (large) to the remote con-
troller and bracket.
t Attach the supplied Velcro pads (small) or rubber pad to
the bracket as shown below; then attach the remote con-
troller.
• When using the optional MB-65
MB-58
MB-65
Adjust the viewing
angle for maximum
visibility of the
function display.
MB-58 IC-208H remote controller
Bracket
When using self-
tapping screws.
Mounting
base
Mounting
bolt
Quick reference guide