Icom IC-208H - Manual (Page 46)

31
5
MEMORY OPERATION
■ Programming channel names
Each memory channel and the call channel can be pro-
grammed with an alphanumeric channel name for easy
recognition and can be indicated independently by channel.
Names can be a maximum of 6 characters— see the table
below for available characters. q Push [S.MW•MW] momentarily.
• “!” and memory channel number blink.
w Rotate the tuning dial to select the desired memory or call
channel.
e Push [BAND] to select the memory name programming
condition.
• Frequency readouts disappear and a cursor blinks.
r Rotate the tuning dial to select the desired character.
• The selected character blinks.
t Push [SET•LOCK] to move the cursor to the right.
y Repeat steps r and t until the desired channel names
are displayed.
u Push [S.MW•MW] for 1 sec. to program the name and exit
the channel name programming condition.
(1)
(B)
(L)
(V)
(+)
(2)
(C)
(M)
(W)
(–)
(3)
(D)
(N)
(X)
(=)
(4)
(E)
(O)
(Y)
( ✱)
(5)
(F)
(P)
(Z)
(/)
(6)
(G)
(Q)
(space)
(7)
( ( )
(H)
(R)
( ) )
(8)
(I)
(S)
(|)
(9)
(J)
(T)
(0)
(A)
(K)
(U)
[EXAMPLE]: Programming “CLUB” into memory channel 1.
Rotate Push Push Rotate
Push for 1 sec.
Repeat the
previous
steps. Beep
Beep
Beep
“
“
“
“
“
Push