Icom IC-208H - Manual (Page 49)

5
MEMORY OPERATION
34
5
■ Memory clearing
Contents of programmed memories can be cleared (blanked),
if desired.
q Push [V/MHz•SCAN] to select VFO mode.
w Push [S.MW•MW] momentarily.
• “!” indicator and the memory channel number blink.
e Rotate [DIAL] to select the memory channel to be cleared.
• Memory channels not yet programmed are blank.
r Push [S.MW•MW] momentarily, then push [S.MW•MW]
again for 1 sec.
☞ This operation must be performed within 1.5 sec.
• 3 beeps sound, then the frequency is cleared.
• “!” indicator and the channel number blink continuously.
• When clearing the call channel, the current VFO conditions are
re-programmed into the call channel automatically.
t Push [V/MHz•SCAN] to return to VFO mode.
☞NOTE: Be careful!— the contents of cleared memories
CANNOT be recalled.
[EXAMPLE]: Clearing memory channel 20.
Push to select VFO. Rotate for selecting memory channel. Push .
Push any switch, except . Push momentarily, then push again for 1 sec.
Beep
Beep
Beep
“
“
“
“
“