Intel Itanium 2 Processor - Manual (Page 31)

Datasheet 31
Electrical Specifications
The power pod provides a selectable output voltage controlled via multiple binary weighted
Voltage Identification (VID) inputs. The VID value (high = 1; low = 0) is defined in
Table 2-23 .
VID pads shall be considered as LVTTL inputs to the power pod, having resistive pull-ups (5 k
Ω)
included inside the power pod to the internal 3.3 V power supply. The VID pads on the power
connector tab will be pulled low with 10
Ω resistors that are internal to the processor. The 10 Ω
resistive pulldowns are controlled by Intel and will not be externally adjustable.
The processor has several power levels as shown in Table 2-24 and in Figure 2-5 . Full power to the
processor is defined in Table 2-2 .
Table 2-23. Processor Core Voltage Identification Code
1
NOTES:
1. Nominal settings require regulation to ±7% at V
CC,PS
pins at the power tab under all conditions.
Processor Pins: 0 = Connected to GND; 1 = Open
V
CC
(VDC)
VID4 VID3 VID2 VID1 VID0
1 1 1 1 1 Output Off
1 1 1 1 0 0.95
1 1 1 0 1 0.975
1 1 1 0 0 1.0
1 1 0 1 1 1.025
1 1 0 1 0 1.05
1 1 0 0 1 1.075
1 1 0 0 0 1.1
1 0 1 1 1 1.125
1 0 1 1 0 1.15
1 0 1 0 1 1.175
1 0 1 0 0 1.2
1 0 0 1 1 1.225
1 0 0 1 0 1.250
1 0 0 0 1 1.275
1 0 0 0 0 1.3
0 1 1 1 1 1.325
0 1 1 1 0 1.35
0 1 1 0 1 1.375
0 1 1 0 0 1.4
0 1 0 1 1 1.425
0 1 0 1 0 1.45
0 1 0 0 1 1.475
0 1 0 0 0 1.5
0 0 1 1 1 1.525
0 0 1 1 0 1.55
0 0 1 0 1 1.575
0 0 1 0 0 1.6
0 0 0 1 1 1.625
0 0 0 1 0 1.65
0 0 0 0 1 1.675
0 0 0 0 0 1.7