Intel Vig390s - Manual (Page 10)

Vig390s Motherboard Manual V1.0 9
Feature Summary
The VIG390S motherboard supports Intel Pentium Xeon™ processors with 1MB of
third-level cache integrated in a micro PGA 604 Socket package operating at speeds
up to 3.6GHz. Single or dual processors are supported but should be identical in
speed and CPU stepping revision.
Table 4: Feature Summary
Form Factor VIG390S: extended ATX (9.8 inches by 12.0 inches [250.00 millimetres
by 305.00 millimetres])
Processor - Single or dual Pentium Xeon CPU
- 800MHz FSB
- Integrated 512MB second and 1MB third level cache
- Socket micro PGA 604 connector
604-pin FC-µPGA4
Supported CPU
speeds CPU Speed FSB L2 Cache L3 Cache
3.2. to 3.6GHz 800MHz 512K 1M
Memory - Four 204-pin DDR2 SDRAM Dual Inline DIMM sockets.
- Support for up to 8GB of DDR2 400 ECC 72bit
Chipset - Northbridge Intel® 7525 Memory Controller Hub (GMCH)
- Southbridge Intel® 6300ESB I/O Controller Hub (ICH5)
- 8 Mbit Firmware Hub (FWH)
Video - PCI-Express connector supporting x1 ,x4, x8 and x16 lane VGA cards
Audio - Audio subsystem using the ADI AD1980 6 channel audio codec.
I/O Controller - Southbridge Intel® 6300ESB I/O Controller Hub (ICH5)
USB - Support for USB 2.0 devices
Peripheral Interfaces - Eight USB Ports
- One Serial Port
- One Parallel Port
- Two Serial ATA IDE interfaces
- Two Parallel ATA IDE interfaces with UDMA 33, ATA-66/100 support
- One diskette drive interface
- PS/2 keyboard port
- PS/2 mouse port
- One IEEE1394a Port
LAN Support Gigabit (10/100/1000 Mbits/sec) LAN subsystem using the
Broadcom BMC5751 PCI Express Gigiabit LAN Controller PCI-E 1.0a
interface
BIOS - AMI BIOS (resident in the 8 Mbit FWH)
- Support for Advanced Configuration and Power Interface (ACPI), Plug
and Play SMBIOS 2.3, WfM2.0,DMA2.0a.
Instantly Available PC
Technology - Support for PCI Local Bus Specification Revision 2.2
- Suspended to RAM support
- Wake on PCI, RS-232, front panel, PS/2 devices and USB ports
Expansion Capabilities - One PCI (32bit 5v) bus add-in card connectors
- Two PCI-X (64bit) bus add-in card connector
- One PCI-Express (x16 lane) add-in card connector
- One PCI-Express (x4 lane) add-in card connector
Hardware Monitor
Subsystem - Hardware monitoring and fan control ASIC
- Voltage sense to detect out of range power supply voltages
- Thermal sense to detect out of range thermal values
- Four chassis fan connectors with activity monitor(two rear and two
front)
- 2 x CPU Heatsink FAN speed activity monitor
- Thermal Fan speed control