Intel Vig390s - Manual (Page 47)

Vig390s Motherboard Manual V1.0 46
Installing & Removing DDR SDRAM In-line Memory Modules
Installing Memory
You can install from 256MB to 8GB of memory in the motherboard DIMM sockets.
The board has four 240-pin DDR2 72bit registered ECC SDRAM DIMM sockets.
The motherboard supports the following memory features:
• 240-pin DIMMs with gold-plated contacts.
• ECC
(72-bit).
• 256MB, 512MB, 1GB and 2GB (in the future) modules.
When adding memory, follow these guidelines:
• The BIOS detects the size and type of installed memory.
Note:
DDR SDRAM’s must meet the JEDEC Solid State Technology Association
specifications.
http://www.jedec.org/
To install DIMMs, follow these steps:
1. Observe the precautions in “Upgrading and ESD precautions”. Turn off the
computer and all peripheral devices.
2. Remove the computer cover and locate the DIMM sockets.
3. Holding the DIMM by the edges, remove it from its antistatic package.
4. Make sure the clips at either end of the socket are pushed away from the socket.
5. Position the DIMM above the socket. Align the two small notches in the bottom
edge of the DIMM with the keys in the socket. Insert the bottom edge of the
DIMM into the socket.
6. When the DIMM is seated, push down on the top edge of the DIMM until the
retaining clips at the ends of the socket snap into place. Make sure the clips are
firmly in place.
7. Replace the computer cover.