Intel Vig390s - Manual (Page 37)

Vig390s Motherboard Manual V1.0 36
Disable 2-3
Disables onboard LAN controller. If set to
disabled this may not be enabled via
additional BIOS setting.
Front Panel audio Jumpers (Front panel audio)
The table below describes the jumper settings; if the jumper removed and the
computer is powered-up then a system boot failure will occur.
Table 16: Front Panel audio Jumpers (Front panel audio)
Function/Mode Jumper Setting Configuration
(Default)
5-6
and
9-10
Allows audio to pass to rear I/O with no front
audio cable.
The audio line signals are routed
back to the line connector.
Front panel
audio
none
Jumpers removed for front panel audio
cable.
Audio line out and mic in signals are
available for front panel audio connectors on this
connector when no jumpers are installed.
Table 17: Front panel Audio Connector
Pin Signal name Pin Signal name
1 MIC_IN 2 Ground
3 MIC_BIAS 4 +5V
5 RIGHT_OUT
6 RIGHT_IN
7 Ground 8 Key
9 LEFT_OUT 10 LEFT_IN
USB power Jumper (USBPW34)
The table below describes the jumper settings; if the jumper removed and the computer is
powered-up then a system boot failure will occur.
Table 18: USB power Jumper (USBPW34)
Function/Mode Jumper Setting Configuration
(Default)
+5
2-3
Default mode +5V connection for USB ports
3 and 4.
+5VSB 1-2
Changing the jumpers to the +5VSB will
enable wake up from suspend with a USB
device connected to USB ports 3 or 4.
USB power Jumper (USBPW12)
The table below describes the jumper settings; if the jumper removed and the
computer is powered-up then a system boot failure will occur.