IBM TotalStorage DS6000 Series - Manual (Page 72)

48 DS6000 Series: Concepts and Architecture
Figure 3-2 Controller failover
This entire process is known as a failover. After failover, controller 1 now owns all the LSSs,
which means all reads and writes will be serviced by controller 1. The NVS inside controller 1
is now used for both odd and even LSSs. The entire failover process should be invisible to the
attached hosts, apart from the possibility of some temporary disk errors.
Failback
When the failed controller has been repaired and restarted, the failback process is activated.
Controller 1 starts using the NVS in controller 0 again, and the ownership of the even LSSs is
transferred back to controller 0. Normal operations with both controllers active then resumes.
Just like the failover process, the failback process is invisible to the attached hosts.
In general, recovery actions on the DS6000 do not impact I/O operation latency by more than
15 seconds. With certain limitations on configurations and advanced functions, this impact to
latency can be limited to 8 seconds. On logical volumes that are not configured with RAID-10
storage, certain RAID-related recoveries may cause latency impacts in excess of 15 seconds.
If you have real-time response requirements in this area, contact IBM to determine the latest
information on how to manage your storage to meet your requirements.
3.1.2 NVS recovery after complete power loss
During normal operation, the DS6800 preserves un-destaged write data using the NVS copy
in the alternate controller. To ensure that these writes are not lost, each controller has a
dedicated battery backup unit (BBU). If this BBU were to fail, the controller would lose this
protection and consequently that controller would remove itself from service. If power is lost to
a single power supply, this does not affect the ability of the other power supply to keep both
BBUs charged, so both controllers would remain online. In other words, there is an affinity
between controllers and BBUs, but not between power supplies and BBUs.
The single purpose of the BBUs is to preserve the NVS area of controller memory in the event
of a complete loss of input power to the DS6800. If both power supplies were to stop receiving
Cache
memory
for even
LSSs
NVS
for odd
LSSs
Failover
NVS
for
even
LSSs
Cache
for
odd
LSSs
Cache
for
even
LSSs
NVS
for
odd
LSSs
Controller 0 Controller 1