Cmmci9013e command: command_name was not found, Cmmci9016e missing parameter name after, Cmmci9010e – IBM TOTAL STORAGE DS8000 User Manual
Page 23: Command, Complete, Successfully, Cmmci9013e, Command_name, Found, Cmmci9014e
Action
Make
sure
that
you
are
running
only
supported
commands.
CMMCI9010E
The
command
did
not
complete
successfully.
Explanation
The
command
did
not
complete
successfully.
Action
Verify
that
you
are
using
the
correct
syntax.
Then
run
the
command
again.
CMMCI9013E
Command:
command_name
was
not
found.
Explanation
You
attempted
to
run
a
command
that
does
not
exist.
Action
Make
sure
that
you
run
valid
administrative
command-line
interface
commands.
Enter
″help″
for
a
list
of
available
commands.
CMMCI9014E
The
parameter
-parameter_name
is
not
valid.
Explanation
You
attempted
to
run
a
command,
but
the
parameter
that
you
specified
is
not
valid.
Action
Run
the
command
again,
specifying
valid
parameters.
Enter
″help
command_name
″
for
a
list
of
valid
parameters.
CMMCI9015E
The
value
value
for
parameter
-parameter_name
is
not
formatted
correctly.
Explanation
The
parameter
that
you
specified
is
not
formatted
correctly.
Action
Run
the
command
again,
specifying
parameter
values
that
are
formatted
correctly.
Enter
″help
command_name
″
for
a
list
of
valid
parameters.
CMMCI9016E
Missing
parameter
name
after
-.
Explanation
You
specified
a
dash,
but
you
did
not
specify
a
parameter
name
after
the
dash.
Chapter
1.
Framework
messages
3