JVC VN-C215V4U - Manual (Page 18)

18
Setup
Mounting on a ceiling (continued)
4.
Remove the inner dome.
The inner dome is secured by 3 clips. Remove
the inner dome from the clips.
5.
Remove the outer case.
(The outer case is not used for this mounting
method.)
A Loosen the camera fastening screws with a
screwdriver.
B Turn the camera in the anti-clockwise
direction and remove the outer case.
6.
Remove the fall-prevention wire.
Remove the fall-prevention wire that is attached
to the camera unit.
7.
Loosen the pan fastening screw.
Note：
● The lens section may be damaged if you
operate it without loosening the pan fastening
screw.
Ⅵ Connection
1.
Mount the fall-prevention wire on the
camera. This wire connects the camera to the
ceiling.
2.
Connect the LAN cable. ( A Pg. 26)
3.
Connect the power cable and the alarm
cable. ( A Pg. 24, 26)
Memo：
● The power cable must not be connected
when PoE is used.
4.
Wind the waterproof tape.
5.
Insert the camera in the ceiling hole.
Mounting the Camera
(continued)
B
A
4
6
5
5
7
Camera
Fastening
Screw
Pan fastening screw
Washer
Inner dome
1
3
2
3
4
Solder or crimp
Insulation tape
Fall-
prevention
wire(not
supplied)
Wind the
waterproof tape.
VN-C215_EN.book Page 18 Monday, November 27, 2006 9:46 AM