JVC VN-C215V4U - Manual (Page 26)

26
Setup
Connect the camera to a hub or computer using
a LAN cable.
Ⅵ When connecting to a hub
Make use of a straight cable.
Ⅵ When connecting to a computer
Make use of a Cross Over cable.
Note：
● Cross cables cannot be used with some
computer models. When connecting VN-
C215V4U directly to a computer, make sure
to check the computer’s LAN specifications in
advance.
Memo：
● Make use of a Category 5 (or higher) cable in
the case of 100BASE-TX.
Connect the alarm input/output cables with
external devices such as a sensor, buzzer, etc.
Note：
● Noises from an external source may cause
malfunctions even when the cable used is
shorter than 50 m. In this case, use a
shielded cable or move the cable away from
the noise source.
LAN Cable Connection
LAN cable
Alarm Input/Output Cable
Connection
Signal name Cable color
Alarm input 1 Pink
Alarm input 2 Blue
Alarm output 1 Orange
Alarm output 2 Yellow
GND Brown
Cable to use
● Length of 50 m or shorter
● UL1007, UL1015 or equivalent products
● AWG#22 - AWG#18 or equivalent products
Solder or crimp
Insulation tape
Wind the
waterproof
tape.
Alarm input/output cables
VN-C215_EN.book Page 26 Monday, November 27, 2006 9:46 AM