JVC VN-C215V4U - Manual (Page 21)

21
4.
Connect the LAN cable. ( A Pg. 26)
5.
Connect the power cable and the alarm
cable. ( A Pg. 24)
Memo：
● The power cable must not be connected
when PoE is used.
6.
Wind the waterproof tape. ( A Pg. 26)
Ⅵ Mounting
1.
Align the secured outer case with the
position alignment mark of the camera.
Note：
● Make sure that the cables are not caught in
the outer case.
2.
Turn the camera in the clockwise
direction.
T Check that the ○ mark can be seen. (Refer
to the diagram below)
3.
Tighten the Camera Fastening Screws
and secure the camera.
Ⅵ Image adjustment
When the camera is mounted, adjust the image
settings while looking at the actual image.
(
A Pg.27 eImage adjustmentf)
Ⅵ Mounting the Dome Cover
After the image adjustment is completed, mount
the dome cover.
Installation is complete when the dome cover is
mounted.
(
A Pg.29 eMounting the Dome Coverf)
FRO
NT UP
3
2 1
Towards
fastening
hook
From the
ceiling slab
Towards the shooting
direction
T Loosen
sufficiently
Fall-prevention
wire
(not supplied)
Outer case
mounting screw
Less than 3 mm
4
5
6
Solder or crimp
Insulation tape
Wind the waterproof
tape.
3
2
1
Position
alignment
mark
Camera
Fastening
Screw
T Check
VN-C215_EN.book Page 21 Monday, November 27, 2006 9:46 AM