JVC VN-C215V4U - Manual (Page 25)

25
Connecting to the DC12 V power supply
Connect this product to the DC12 V power
supply when not using the PoE.
Connect the polarity correctly.
Note：
● Make sure to select only one mode of
electrical supply. Connecting the power cable
and the LAN cable for the PoE at the same
time may result in failure or malfunction of the
camera.
Memo：
About the power cable
● When using 2-core VVF (Vinyl-insulated
vinyl-sheath cable), the connection distance
is as follows: (Reference value)
Memo：
● In a system where multiple units of VN-
C215V4U are used, turn on the power of only
1 unit to configure the IP address settings via
the Internet Explorer. Upon doing so, turn on
the power of the second unit and configure
accordingly. Configure the camera settings
using the same procedure.
● Whenever duplication of IP addresses
occurs, check that there is only one VN-
C215V4U under the same LAN environment
and wait for at least 10 minutes. Access to
VN-C215V4U may be denied unless you
restore the power supply of all network
devices under the same LAN environment.
● To use AA-P700 in the power supply unit,
connect one unit of this product. Also refer to
the AA-P700 instruction manual.
Red : DC12V+
Black : DC12V-
Maximum
extension (m) 40 120 190
Conductor
Diameter (mm) R1.0 and
above R1.6 and
above R2.0 and
above
Power cable
Red: DC12 V+ Black: DC12 V-
Solder or
crimp Solder or
crimp
Insulation tape Insulation tape
Wind the
waterproof
tape.
Warning
The rated power of this product is DC12 V.
Make sure to use it with the correct voltage.
Supplying a power different from the rated
value may result in failures and in the worst
scenario, smoking and fire.
VN-C215_EN.book Page 25 Monday, November 27, 2006 9:46 AM