John Deere OMPFP10808 - Manual (Page 16)

Setup
CZ76372,00001CE ­19­12OCT10­2/2
PC10802
—UN—08JUL08
Machine Tab
A—Machine Tab
B—Implement 1 Tab
C—Machine Type Drop­Down
Menu
D—Machine Model Drop­Down
Menu
E—Machine Name Drop­Down
Menu
F— Connection Point Drop­Down
Menu
G—Machine Turn Radius
Input­Box
H—Turning Sensitivity Input­Box
I— Change Offsets Button
J— Recording Source Drop­Down
Menu
K—Record/Pause Button
L— Enable Monitoring Without
GPS Check Box
NOTE: Machine name must be defined in order to
change offsets. All offsets will be saved under
the current machine name.
The Machine tab is required to be populated with the
following equipment information:
• Machine Type—Vehicle type being used (Example:
Tractor).
• Machine Name—Allows the operator to save
vehicle­specific offsets.
• Connection Type—Defines how the implement is
attached to the machine.
­ Rear Rigid 3­pt (not compatible with iGuide)
­ Rear Pivot 2­pt
­ Rear Pivot Drawbar
­ Rear Pivot Wagon Hitch (for European use)
­ Front Rigid 3­pt (not compatible with iGuide)
• Machine Offsets—modify by pressing Change Offsets
button (I).
• Verify offsets correspond to the machine selected.
Machine Model—Model number of the vehicle being used.
For John Deere vehicles, model numbers will be available
from the drop­down list.
NOTE: Machine Model is not required for iGuide operation.
NOTE: Machine Turn Radius and Turning Sensitivity
are for use with iTEC Pro only.
15­3 102110
PN=16