John Deere OMPFP10808 - Manual (Page 40)

Tuning Guide
JS56696,00006D8 ­19­31AUG09­1/1
Continued on next page CZ76372,00001E2 ­19­12OCT10­1/3
Setting Up Implement Offsets
Implement Offsets
Offsets “A”, “B”, and “D” are critical for iGuide to operate
efficiently.
Offset “E” is not required for iGuide.
NOTE: Offset “C” is required when using a non
centered implement.
A—In­line distance from
connection point to front of
implement.
B—In­line distance from front
to rear of implement.
C—Lateral distance from
connection point to control
point of implement.
D—In­line distance from
connection point to control
point of implement.
E—In­line distance from
connection point to
connection point for
second implement. Value
only needed if second
implement is used.
F— Offset Toggle Button
G—A+B Documentation/Swath
Control location when in
use.
PC1
1838
—UN—20MAR09
Offsets
Setting Up Implement GPS Offsets
Implement GPS Offsets
Offsets “A”, “B”, and “C” are critical for iGuide to operate
efficiently.
A—In­line distance from
connection point to GPS
receiver.
B—Lateral distance from
implement center to GPS
receiver.
C—Vertical distance from GPS
receiver to ground with
implement engaged.
D—Lateral offset toggle button
E—Verify implement fore/aft
and offsets in the StarFire
setup pages.
PC1
1841
—UN—23MAR09
GPS Offsets
30­2 102110
PN=40