John Deere OMPFP10808 - Manual (Page 44)

Troubleshooting
CZ76372,00001E3 ­19­12OCT10­2/2
JS56696,000050A ­19­10DEC08­1/1
­ Always verify correct implement dimensions
when using the “out of box” dimensions from the
GreenStar Display or Apex.
Valid Configuration
iGuide requires certain settings to be available and certain
offsets need to be within a defined range. If one of these
constraints is not given, tracking cannot be activated.
For a new, unknown implement, all offset will be zero as
a default.
General constraints:
• Will not work with 3­pt implements.
• Implement receiver installed and set up to be an
implement receiver.
• Both receivers need to have the same differential
correction level (RTK).
The following settings and constraints are mandatory for
the machine:
• Machine type and name selected.
• Rear pivot connection type selected.
• Distance between connection point and non steering
axle is larger than 30 cm (11.8 in.).
The following settings and constraints are mandatory for
the implement:
• Implement type, name, and model are selected.
• Distance between connection point and control point
shall be larger than 49 cm (1.6 ft).
• Location of implement receiver is defined.
• The distance between the connection point and the
implement GPS receiver needs to be larger than 201
cm (79 in.).
• Lateral offset from control point to implement GPS
receiver shall be less than 201 cm (79 in.).
The following settings and constraints are mandatory for
the implement GPS receiver:
• Implement receiver height should be between 50 cm
(20 in.) and 508 cm (200 in.).
A—View Drop­Down Menu
B—Information Column
C—Current Column
D—Status Column E—Previous Page
F— Next Page
G—Valid Range Column
PC1
1846
—UN—24MAR09
Implement Guidance diagnostics page 1
PC1
1797
—UN—09MAR09
Implement Guidance diagnostics page 2
35­2 102110
PN=44