John Deere OMPFP10808 - Manual (Page 3)

Contents
Page
Safety .......................................................... 05­1
Getting Started
Theory of Operation............................................10­1
Making Implement Guidance Function ...............10­2
Accuracy.............................................................10­2
iGuide Activation.................................................10­3
Useful Buttons and Icons....................................10­3
Setup
Getting Started ...................................................15­1
Machine Setup....................................................15­2
Machine Offsets..................................................15­4
Implement Setup ................................................15­6
Implement Offsets ..............................................15­8
Implement GPS Offsets....................................15­10
Measuring in line dimension from
receiver to receiver.......................................15­10
Receiver Installation ......................................... 15­11
GPS Receiver Setup ........................................15­12
TCM Calibration................................................15­15
Guidance Setup................................................15­17
Operation
Operation of iGuide ............................................20­1
Integrating iGuide and iTEC Pro
Hardware and Software Requirements ..............25­1
Hardware and Software Requirements ..............25­1
Setup ..................................................................25­1
Operation............................................................25­2
Using Implement Receiver
forDocumentation and Coverage Map ...........25­3
Tuning Guide
Setting Up Vehicle Offsets..................................30­1
Setting Up Implement Offsets.............................30­2
Setting Up Implement GPS Offsets ....................30­2
Tuning Slope Compensation ..............................30­4
Tuning iGuide Sensitivity ....................................30­4
Troubleshooting
Troubleshooting Tips ..........................................35­1
Valid Configuration .............................................35­2
Specifications
Metric Bolt and Screw Torque Values.................40­1
Page
Unified Inch Bolt and Screw Torque Values........40­2
Original Instructions. All information, illustrations and specifications in this
manual are based on the latest information available at the time of publication.
The right is reserved to make changes at any time without notice.
COPYRIGHT © 2009
DEERE & COMPANY
Moline, Illinois
All rights reserved.
A John Deere ILLUSTRUCTION ® Manual
i 102110
PN=1