John Deere OMPFP10808 - Manual (Page 27)

Setup
JS56696,0000505 ­19­01APR09­4/4
Enter the correct receiver height above the ground. To
measure the receiver height, put the implement at its
working depth (if possible) and measure the height. If this
is not possible, lower the implement to the ground, and
subtract the desired working depth to get the value to
be entered.
Example: 2210 field cultivator—Lower the implement so
the sweeps are on the ground. Measure the height from
the ground to the top of the receiver. Subtract the working
depth from this number and enter as the receiver height.
If the height measured equals 180 cm (71 in.) and your
desired working depth is 10 cm (4 in.), enter 170 cm (67
in.) as the receiver Height.
NOTE: Enter 0 for the Fore/Aft offset for the
implement receiver.
Hours After Shutdown— The use of this feature is
recommended when two StarFire receivers are connected
on the CAN Bus to prevent excessive battery discharge.
Set hours after shutdown between 3 and 12 hours.
For optimized performance make the Hours On After
Shutdown the same value as on the machine receiver.
PC1
1208
—UN—14JUL08
Rear View Of Mast
15­14 102110
PN=27