JVC VN-C215VP4U - Manual (Page 10)

10
Introduction
Camera unit
A Mounting hole ן 2
Use these when mounting the base to the
ceiling, wall or electrical box.
(
A Pg. 17)(A Pg. 21)
Note：
● To mount the camera using an electrical box,
please check with your dealer or nearest JVC
servicing center.
B Holes for connection cable and piping
This hole is for pulling out the connection cable.
You can also use this hole to mount the camera
directly on the piping. (Piping hole: G3/4-
14UNC)
(
A Pg. 22)
C Fall-prevention wire mounting screw
This is used to mount the fall-prevention wire to
the camera. (The fall-prevention wire is not
supplied.)
Note：
● Connect the fall-prevention wire to prevent
the camera from dropping.
D Piping hole plug/Piping hole (side)
This is used to mount the camera directly on the
piping from the side. A piping hole plug is
attached to this hole by default. (
A Pg. 23)
E Dome cover
The dome cover is fragile. Take care when
handling it.
F Inner dome
Before mounting the camera, remove it and
perform image angle setting.
(
A Pg. 17)
G Dome cover fastening screw
These are fastening screws for the dome cover.
H Base
Mount the base to the ceiling, wall or electrical
box before mounting the camera.
(
A Pg. 17)(A Pg. 21)
Name and Function of Parts
B
E
C
A
D
F
H
K
G
J
I
VN-C215VP_EN.book Page 10 Wednesday, December 20, 2006 4:26 PM