Mounting the inner dome, Mounting the dome cover, Mounting the inner dome mounting the dome cover – JVC VN-C215VP4U User Manual
Page 30: A pg. 30), R (a pg. 30), Nner dome (a pg. 30)
30
After all settings are complete, mount the inner
dome to the camera.
1.
Mount the inner dome
Mount the inner dome to the claws (x3).
Note：
● Mount the inner dome without covering the
lens.
● When mounting the inner dome, make sure
that the position of the lens is not shifted.
Otherwise, the configured field angle will be
distorted.
1.
Clean the dome cover
Before mounting, remove and clean any dust or
dirt on the dome cover.
Memo：
● Dirt on the dome cover may be reflected in
the images.
Note：
● Do not pull or apply excessive force to the
dome cover.
2.
Mount the dome cover to the base
Align the base with the position alignment marks
(x3) on the dome cover and mount the dome
cover.
3.
Secure the dome cover
Tighten the dome cover fastening screws (x3)
with wrench (supplied) and secure.
38
Mounting the inner dome
Claw
(3 locations)
Inner
dome
Mounting the dome cover
2
3
Position alignment marks
(3 locations)
Wrench (Supplied)
VN-C215VP_EN.book Page 30 Wednesday, December 20, 2006 4:26 PM