JVC VN-C215VP4U - Manual (Page 19)

19
Fill up the piping hole and mounting hole with
sealant, mount the camera to the base and
insert silica gel.
1.
Fill up the holes with sealant
Use sealant to fill up the mounting holes (x2) to
which the piping hole and screws are mounted.
Memo：
● Use GE silicon or other equivalent for the
sealant.
Note：
● If the mounting holes (x2) are not completely
sealed up with sealant, water or moisture
may seep in and fog up the lens and dome
cover. Seal up these holes completely.
2.
Mount the camera to the base
Push in the two claws until you hear a click
sound.
Note：
● Mount the camera such that the cables and
fall-prevention wire of the dome cover are not
caught in between.
3.
Secure the camera with the camera
fastening screws (x2).
Tighten the camera fastening screws (x2) with
the screw driver and secure the camera.
Mounting the camera
Sealant
2
3
Claw
(2 locations)
VN-C215VP_EN.book Page 19 Wednesday, December 20, 2006 4:26 PM