JVC VN-C215VP4U - Manual (Page 18)

18
Setup
2.
Mount the fall-prevention wire to the base
(The fall-prevention wire is not attached)
Remove the fall-prevention wire mounting screw
of the base and mount the fall-prevention wire.
Note：
● Also pay careful attention to the length,
strength, wiring and material (insulation
quality) of the fall-prevention wire to be used.
● For the fall-prevention wire, the inside
diameter of the ring section to be mounted on
the camera unit should be between
R4.1 mm
and R6.5 mm, and the outside diameter
should be below R12 mm.
3.
Mount the fall-prevention wire to a strong
location.
Mount the fall-prevention wire to a strong
location to prevent fall.
4.
Mounting the base
Face the imaging direction mark inside the base
(
j) in the shooting direction and mount the base.
When mounting to a wall, face the imaging
direction mark (
j) upwards.
Use two R4 mm screws for mounting.
Note：
● When mounting to a wall, be sure to face the
imaging direction mark ( j) upwards.
● R4 mm screws are not supplied. Use the
appropriate type according to the material of
the location for mounting.
● The two attached screws (M4 ן8 mm) are
for mounting the base to the adapter plate.
Do not use them here.
1.
Connect the LAN cable ( A Pg. 26)
2.
Connect the power cable, alarm cable and
heater cable
(
A Pg. 24)(A Pg. 26)(A Pg. 27)
Memo：
● The power cable must not be connected
when PoE is used.
● When the camera is installed with a heater
(sold separately: KA-ZH215), be sure to
connect it to AC 24 V power supply.
● The AC 24 V power supply should conform to
the following : Class 2 only (For USA),
Isolated power supply only (For Europe).
3.
Wind the waterproof tape
Note：
● Be careful not to drop the camera when it is
removed from the base.
Mounting the base (continued)
2
4
8 mm
2 mm
3
Fall-prevention
wire
Base
R4 mm screw
Towards the shooting
direction
(Face upwards when
mounting to wall)
Cable connection
2
3
1
Solder or crimp
Wind the insulation tape
Wind the
waterproof tape
Power cable, alarm
cable
LAN cable
LAN cable
10BASE-T/
100BASE-
TX(PoE)
terminal
VN-C215VP_EN.book Page 18 Wednesday, December 20, 2006 4:26 PM