JVC VN-C215VP4U - Manual (Page 26)

26
Setup
Note：
● When installing a heater unit (sold
separately: KA-ZH215) to this product, be
sure to connect to AC 24 V.
● When installing a heater unit (sold
separately: KA-ZH215), read the heater
instruction manual carefully before installing.
● The AC 24 V power supply should conform to
the following : Class 2 only (For USA),
Isolated power supply only (For Europe).
● Please consult your nearest JVC dealer
regarding heaters.
ⅷ About heater cables
Connect the camera to a hub or computer using
a LAN cable.
Ⅵ When connecting to a hub
Make use of a straight cable.
Ⅵ When connecting to a computer
Make use of a Cross Over cable.
Note：
● Cross cables cannot be used with some
computer models. When connecting VN-
C215VP4U directly to a computer, make sure
to check the computer’s LAN specifications in
advance.
Memo：
● Sealed cables are recommended for outdoor
use.
● Make use of a Category 5 (or higher) cable in
the case of 100BASE-TX.
Heater cable connection
Maximum
extension 40 m
(130 ft) 120 m
(390 ft) 180 m
(590 ft)
Conductor
Diameter
(mm) R1.0 R1.6 R2.0
Wind the
waterproof tape
Heater power cable
(White, Gray)
Solder or
crimp
Insulation tape
AC24 V power supply
LAN Cable Connection
LAN cable
10BASE-T/
100BASE-
TX(PoE)
terminal
VN-C215VP_EN.book Page 26 Wednesday, December 20, 2006 4:26 PM