Jacuzzi J - 470 - Manual (Page 65)

Page 59
J-400 Series
13.0 Programming Instructions for settings 2 menus
The “Settings 2” screen allows you to program Heating, Primary Filter
and Secondary Filter modes.
13.1 Programming Heating Cycles
Your Jacuzzi spa is equipped with two modes of heating. An
automatic mode called “Auto-Heating”, where the spa’s temperature is
maintained at all times by the “Setpoint”. The second mode is called
“Programmable”, where the spa will only activate the heater at set times
programmed by you. To activate either mode follow the procedures
below.
To access the “Settings 2” Menu:
1. From the Settings 1 Menu (Figure A), press button B.
2. The “Settings 2” Menu will appear (Figure B).
note: You can return to the factory default heating and filtration modes
by pressing the Splash button on the Quad Keypad while in the Settings
2 Main Menu (Figure B) at any time.
D
C
B
A
Press to
set filter timer
Language
Ozone
Filter
OFF
ENG
5 4 3
SETTINGS 1
Figure A
D
C
B
A
Primary
Secondary
Heating
Press to
reset to default
SETTINGS 2
OFF
Figure B