4 ozone water maintenance system (optional), 0 error/display messages – Jacuzzi J - 470 User Manual

Page 79

Advertising
background image

Page 73

J-400 Series

15.4 Ozone water maintenance system (Optional)

This system is optional on North American models and standard

equipment on export 50 Hz modes. If you spa is equipped with the

Jacuzzi CD ozone water purification system you will find that your water

stays fresh and clear with significantly less chemical usage. You will

probably be able to go longer between complete spa drainings.

note: To maximize sanitation benefits from this product, always turn off

the spa waterfall valve when the spa is covered or not in use. This setting

ensures maximum water flow through the ozone injector and higher

ozone concentrations. The ozone only runs when the circulation pump is

running and shuts off when either jets pump is manually activated during

spa use. The circulation pump will remain off for 5 minutes after both jets

pumps time out or are manually turned off, then resume operation as

programmed.

16.0 error/Display messages

There are a number of unique functions designed into your Jacuzzi spa

to protect it from damage and/or to aid in troubleshooting. When an error

occurs the spa will notify you by showing the screen below and an error

code next to it. Following is a listing of all the possible messages along

with their meanings:

1.

Overheat protection: (Heater is deactivated, filter/circulation pump is

activated). Water temperature is above acceptable limits. DO nOT

enTer THe waTer! Remove spa cover to speed cooling. See

“Water Is Too Hot” on page 78. If condition persists, contact your

authorized dealer or authorized service center.

2. Water is below set-temp: If the spa water is more than 20 °F/6 °C

cooler than the temperature set point, the circulation pump and

heater will automatically activate to provide freeze protection. The

spa will stay in this mode until the water temperature reaches

15 degrees below the set temperature. No corrective action is

necessary.

98

F

Temp.

4:05 PM

!

“Displays

Error

Message”

warnInG: rIsK OF HYPerTHermIa (OVer-HeaTInG)

Causing severe inJury, burns, or welts.

!

Advertising
This manual is related to the following products: