1 cleaning the filter cartridges, 67 (sec. 14.0) for additional information, Age 67 – Jacuzzi J - 470 User Manual

Page 73

Advertising
background image

Page 67

J-400 Series

14.1 Cleaning the Filter Cartridges

A programmable “Please Check Filter”

reminder appears on the control panel

display after a specified number days to

remind you to clean the skimmer filter and to

check the polishing bag filter. This reminder

must be reset at each filter cleaning interval.

Refer to Section 12.3 (page 56) for additional

information and programming details. Your new spa is equipped with an

advanced 2-stage filtration system. Fine debris are filtered by the

circulation pump drawing water through the ProClear™ skimmer and

pleated filter cartridge 12 hours (unless programmed otherwise). Large

debris are filtered when either jets pump is running when the spa is in

use or during a programmed filter cycle. These pumps draw water from

footwell suction fitting and through a secondary water polishing bag filter

and additional filter. The exclusive footwell “sweeper” suction fitting

enhances filtration in the footwell area by creating a “swirling” water
motion to maximize particle agitation and pickup.

To ensure optimum performance, the ProClear™ II

skimming filter cartridge (A) must be cleaned every

three months and replaced once a year. The secondary

ProClear™ Plus polishing filter bag (B) should be emptied

weekly and replaced every 3 months. The ProClear™ II

filter cartridge (C) must be cleaned every three months

and replaced once a year. To accomplish this, refer to the

following filter cleaning procedure.

note: Do not attempt to wash the polishing filter bag (B)
or it will come apart!

DanGer: Turn POwer TO sPa OFF! TO DeCrease rIsK OF

Death, Drowning, or entraPMent, never oPerate sPa when

Filter is not ProPerly installeD or iF weir asseMbly is
DamaGeD Or alTereD!

A

B

2.

1.

4.

5.

3.

1. Remove power to the hot tub before removing the skimmer

(A) or filter bag cover (B).

2. Remove the polishing bag lid (B) by rotating it counterclockwise

approximately 5 degrees until you feel it unlatch.

3. Remove the polishing bag by reaching into the filter bucket and

gently pulling upward on the blue filter ring (empty filter bag weekly

102

F

Temp.

6:45 PM

Please check filter!

a

b

C

Advertising
This manual is related to the following products: