Japan Tiger 7100e+ - Manual (Page 153)

User Manual 153
English
3 Check [Use DHCP/BOOTP] or [Use RARP] in the TCP/IP
setting window and click [Setup]. 5 To make the new settings take effect, click [Yes].
4 If the settings are correct, click [Yes]. The settings are
transmitted to the Fast EtherNet.
At this point, the Fast EtherNet is still operating with
the previous settings.
If you select [NO], the new settings will take effect
when the printer is turned off and then back on again.
You may need to power cycle the printer depending
on the model.
7100e+.p65 25/08/99, 20:55 PM 153