Japan Tiger 7100e+ - Manual (Page 53)

User Manual 53
English
Printing From UNIX
In order to print from a UNIX workstation using TCP/IP, the
Fast EtherNet and UNIX workstations must be configured.
Configuring the IP address in the Fast EtherNet
The first step is to configure the Fast EtherNet with an IP address,
subnet mask and gateway address. This can be done from the
UNIX workstation.
· To change the configuration of the Fast EtherNet, you
must log into the card and username”root”, the initial
value of the “root” user password is <none>.
· If you type in a wrong IP address, subnet mask or
gateway, the network may go down or other severe
damage may occur. Please set the configuration only
after consulting your network manager.
In the following explanation, Sun Solaris2.4 is used as an
example. The method of configuring each command etc. may
differ from one workstation to another. Please refer to the manual
of the UNIX workstation used.
7100e+.p65 25/08/99, 20:50 PM 53