Japan Tiger 7100e+ - Manual (Page 98)

Fast Ethernet 7100e+ 98
Allocating Print Queue to Printer
1 Select “Queues Serviced by Printer” and press the Enter key.
Print Server Configuration Menu
File Server Assigned
Printer Notification List
Queues Serviced by Printer
Printer Configuration
2 Select from “Pre-defined Printers” the printer to which a
print queue is to be allocated (“OP8C”). Press the Enter key.
3 Press the Ins key to select the print queue to be allocated to
the printer (“Q8C”). Press the Enter key.
4 Enter the priority for the print queue.
The print queue and its priority is assigned.
For allocating several print queues, repeat steps 3 and 4.
File Server Queue Priority
SOFT22-NW312 Q8C 1
Closing PCONSOLE
Press the Esc key until [Exit?] appears on the screen, then
select [Yes].
Printing in Print Server Mode
1 Use the utility to set the Fast EtherNet.
2 Follow the procedure for “Setting Fast EtherNet” via the
bindery network in NetWare 4.1 print server mode earlier in
this chapter.
Printing in Remote Print Mode
1 Start the print server (“8C-PSERVER” in this example) on
the file server console.
:LOAD PSERVER 8C-PSERVER
If the print server has already been running, check that no-
one is using it before restart it.
:UNLOAD PSERVER :LOAD PSERVER 8C-PSERVER
2 Set the Fast EtherNet using the utility.
Follow the procedure for “Setting Fast EtherNet” in NetWare
4.1 remote printer mode earlier in this chapter.
7100e+.p65 25/08/99, 20:51 PM 98