Japan Tiger 7100e+ - Manual (Page 92)

Fast Ethernet 7100e+ 92
Configuring the Fast EtherNet
This section explains how to use the Standard Setup Utility for
Windows. You can also make these changes using the Setup Utility
on a Macintosh or via TELNET. Read the following description
and choose the appropriate utility for your network environment.
• Use the utility when the NetWare file server and the
print server are running normally.
• Ensure that the printer is switched on as the Fast
EtherNet cannot be configured when the printer is off.
This procedure assumes that the Standard Setup Utility has
already been installed. For information on installing the utility,
see “CHAPTER 7 Control of Fast EtherNet”.
1 Select the Fast EtherNet to be configured from the list.
The Ethernet address is displayed on the Fast EtherNet
self-diagnostics test. If there are many NetWare file
servers, there may be cases where the list is not displayed.
In that case, select [Environment Settings] in the
[Options] menu and click the [NetWare] tab. Select
[Specify network to be searched], enter the NetWare
address where the Fast EtherNet exists, then click [Add].
If you click [Search for OKI Devices] in the [File] menu
on the main screen, only the NetWare addresses you
have specified will be searched.
7100e+.p65 25/08/99, 20:51 PM 92