Sharp AR-M205 - Manual (Page 22)

20
COPY FUNCTIONS
Auto paper select mode
When the AUTO PAPER SELECT indicator lights up, "Auto paper select mode" is enable. This function
automatically selects the paper that is the same size as the original (5-1/2" x 8-1/2", 8-1/2" x 11", 8-1/2" x 11"R,
"8-1/2" x 14" and 11" x 17" paper). "Auto paper select mode" can be disabled in the user programs. (p.44)
• If a zoom setting is selected after placing the original, the paper size that is appropriate for the zoom setting will
be automatically selected.
• "Auto paper select mode" is canceled if the auto zoom select function is enabled (p.22) or if a tray is selected
with the [TRAY SELECT] key ( ). Auto paper select resumes operation when the [CLEAR ALL] key ( ) is
pressed or when "Auto clear time" activates.
Removing the document cover
To copy large originals like newspapers, remove the
document cover. To remove the cover, lift straight
up as shown. To replace the cover, do the reverse.
The SPF/RSPF cannot be removed.
Copying books or originals with folds or
creases
Press down on the document cover/SPF/RSPF
while copying as shown. If the document
cover/SPF/RSPF is not completely closed, shadows
may appear on the copy or it may be fuzzy. Fan
originals with folds or creases well before placing.
Originals that can be used in the SPF/RSPF
Originals that are 5-1/2" x 8-1/2" to 11" x 17" and 15
lbs. to 24 lbs. (56 g/m
2
to 90 g/m
2
) can be used. A
maximum of 40 pages can be placed at once.
Originals that cannot be used in the
SPF/RSPF
The following originals cannot be used. These may
cause misfeeds or smudging and unclear images.
• Transparencies, tracing paper, other transparent or
translucent paper, and photographs.
• Carbon paper, thermal paper.
• Originals that are creased, folded, or torn.
• Glued originals, cut-out originals.
• Originals with binder holes.
• Originals printed using an ink ribbon (thermal
transfer printing), originals on thermal transfer
paper.
Stream feeding mode
If "Stream feeding mode" is enabled in the user
programs (p.44), the SPF/RSPF indicator will blink
for about 5 seconds after all originals are fed. If a
new original is placed in the SPF/RSPF during this
time, the original will automatically feed in and
copying will begin.
• Make sure that there are no paper clips or
staples on the original.
• Straighten curled originals before placing
them in the document feeder tray. Curled
originals may cause misfeeds.
• When using the margin shift function,
check the position of the margins
carefully. (p.36)
Note