Sharp AR-M205 - Manual (Page 63)

61
TROUBLESHOOTING
6
Notice page printed
If you find that a notice page has been printed at the end of a print job, the print data received from the computer has
not been printed as specified. Fix the problem as explained below and then try printing again.
What to do when a notice page is printed, 1
The above notice page is printed if you attempt to print
using the print driver for the dual function board when
the dual function board is not installed. Change to the
standard print driver and print again. If the standard
print driver is not installed, install as explained in the
Software Setup Guide.
What to do when a notice page is printed, 2
The above notice page is printed when a print job
containing more data than can be held in the memory
of the dual function board is sent to the machine. To fix
the problem, disable the ROPM function. If you need to
use the ROPM function, set the print quality in the
printer driver to "Draft", or increase the amount of
memory on the dual function board.
Removing the software
If you need to remove the software, follow these steps.
1
Click the "start" button, and then click
"Control Panel".
On Windows 95/98/Me/NT 4.0/2000, click the
"Start" button, select "Settings", and then click
"Control Panel".
2 Click "Add or Remove Programs".
On Windows 95/98/Me/NT 4.0/2000, double-click
the "Add/Remove Programs" icon.
3
Select the printer/scanner driver for
the machine and Button Manager from
the list, and remove the software.
For more information, refer to your operating
manual or to the help files for your operating
system.
****************************************************
Notice Page
****************************************************
The incorrect driver is chosen, a normal
output was not able to be excuted.
Please install the appropriate driver.
Please refer to the operation manual for
the solution method.
The IMC memory is used to temporarily hold
print data when the ROPM function is used.
This memory is also used to temporarily hold
the original image during copying. The
proportion of IMC memory allocated to the
printer function can be changed in the user
programs of copy mode. See the user
program "Memory allocated to printer mode".
(p.46) It is also possible to expand memory by
adding on a commercially available memory
module. For more information on expansion
memory, contact a SHARP service center.
****************************************************
Notice Page
****************************************************
The IMC memory full error had occurred,
a normal output was not able to be executed.
Please refer to the operation manual for
the solution method.
Note