Sharp AR-M205 - Manual (Page 39)

37
3
ERASING SHADOWS AROUND THE
EDGES OF A COPY
(Erase copy)
● This feature is used to erase shadows that appear around the edges of copies of books and other thick originals.
(EDGE ERASE)
●
The feature can also erase the shadow that appears down the center of books and other originals that open up.
(CENTER ERASE)
● The factory default setting for the width of the erasure is approximately 1/2". The width can be changed in the
user programs. (p.45)
1 Place the original(s). (p.18)
2 If the original is placed on the
document glass, select the original
size. (p.18)
When using the SPF/RSPF, make sure that the
same ORIGINAL SIZE indicator as your original
size lights up.
3 Press the [ERASE] key to select the
desired erase mode.
To select the "EDGE +
CENTER ERASE" mode,
press the [ERASE] key
until both the EDGE and
CENTER indicators light
up.
4 Set the number of copies and other
settings, and then press the [START]
key (
).
The copy is delivered to the paper output tray.
A A
A B A B
A B A B
EDGE ERASE
CENTER ERASE
EDGE + CENTER ERASE
Original Copy
Original Copy
Original Copy
• Center erase cannot be used in combination with dual page copy.
• Erase copy cannot be used in combination with 2 IN 1 / 4 IN 1 copy. (p.34)
• Erase copy cannot be used when the paper is a special size or copying from the bypass tray.
• Note that if the width of the erasure is too large, the edge of the image may be partially erased.
Note
EDGE
ERASE
CENTER
• To cancel erase copy, press the [ERASE]
key repeatedly until the ERASE indicators
are both off.
• If the original size was not selected in step
2, erase copy cannot be used.
Note