Sharp AR-M205 - Manual (Page 65)

63
6
MISFEED REMOVAL
When a misfeed occurs, the misfeed indicator ( ) and a misfeed location indicator ( ) will blink and the machine
will automatically stop.
Check the blinking misfeed location indicator to identify the location of the misfeed and remove it.
MISFEED IN THE SPF/RSPF
1
Remove the misfed original.
Check sections A, B, and
C in the left shows the
illustration (see the next
page), and remove the
misfed original.
Section A
Open the feeding roller cover and remove the
misfed original from the document feeder tray.
Close the feeding roller cover.
Section B
Open the SPF/RSPF and rotate the two release
rollers in the direction of the arrow to feed the
original out. Close the SPF/RSPF and then
remove the original.
If a small original (5-1/2" x 8-1/2", etc.) is misfed,
or if an original misfeed occurs in the reversing
tray of the RSPF (if installed), open the right
side cover and remove the original. Close the
right side cover.
The paper may tear when you remove a misfeed. In this event, be sure to remove all torn pieces of paper from the
machine, taking care not to touch the photoconductive drum (the green part). Any scratches or damage to the
surface of the drum will cause dirty copies.
Note
(p.63)
(p.64)
(p.68)
(p.69)
AR-M205
(p.63)
(p.64)
(p.68)
AR-M160
Feeding roller cover
Roller
Right side cover