Sharp AR-M205 - Manual (Page 53)

51
USER SETTINGS
5
Resetting account
(program No.15)
The copy count of a single account or all accounts can
be reset to 0. If no account numbers have been
established, the error code "15E" will appear in the
display.
[Resetting all accounts]
Press the [1] key and then press the [START]
key (
).
The copy counts of all accounts will be deleted.
[Resetting a single account]
1 Press the [0] key.
2 Select the account number to be reset with
the [Copy ratio display] key (
) and then
press the [START] key ( ).
Copying when "Auditing mode" is
enabled
When "Auditing mode" is enabled, "- - -" appears in the
display.
1
Enter your 3-digit account number
with the numeric keys.
When you enter your account number, "0"
appears in the display to indicate that copying is
possible.
2 Follow the appropriate steps to make
the copy.
3
When finished, press the [AUDIT
CLEAR] key.
To reset another account, enter the program
number (15) for account resetting and then
repeat step 2 of "Resetting a single account".
Note
If you enter an incorrect number, press the
[CLEAR] key (
) and then enter the correct
number.
If you are performing an interrupt copy (p.31),
be sure to press the [INTERRUPT] key (
)
when finished to exit interrupt mode.
If a misfeed occurs or the paper runs out
during copying, your session will not end even
if the [AUDIT CLEAR] key is pressed.
Note
Note
AUDIT CLEAR
Note